grbl controller 安装在树莓派上

grbl controller 安装在树莓派上

http://zapmaker.org/raspberry-pi/running-grbl-controller-on-raspberry-pi/

按照方法测试成功。最好命令复制。不要自己输入 。

  1. sudo apt-get update (required for AlaMode)

  2. sudo apt-get install xrdp

  3. sudo apt-get install arduino (required for AlaMode) [For normal Pi, this step is optional, but good to have. NOTE: I got an error that not all items could be downloaded. I tried to repeat command by adding a --fix-missing, i.e. sudo apt-get install --fix-missing arduino but it didn't help. UPDATE: The latest download as of May 2013 doesn't have this problem]

  4. sudo apt-get install libudev-dev

  5. sudo apt-get install qtcreator [This step takes quite awhile to complete. Note: I got an error downloading as in a previous step. If you get an error, repeat command but add a --fix-missing, i.e. sudo apt-get install --fix-missing qtcreator, in this case the --fix-missing worked.]

  6. sudo apt-get install git

  7. mkdir github

  8. cd github

  9. git clone https://github.com/zapmaker/GrblHoming

  10. curl http://www.shapeoko.com/wiki/images/6/6a/Coaster.txt > Coaster.nc

  11. cd GrblHoming

  12. qmake GcodeSenderGUIthreads.pro

  13. make

Make sure that you have your Grbl/Arduino plugged into the pi prior to running the last command:
 
./GrblController


发表评论

必填

选填

选填

◎欢迎参与讨论,请在这里发表您的看法、交流您的观点。

Powered By Z-BlogPHP 1.5.2 Zero

Copyright 175.es Rights Reserved.